As a common presence in modern life, thermal paper label is widely used in various daily items, such as express delivery, book covers, product packaging, etc. However, when removing thermal paper label, there are often situations that are difficult to clean, which requires us to learn some methods of cleaning thermal paper label. Below SHIRLEY YA will introduce you to a variety of methods for cleaning thermal paper label.

1. Scraping method

When the sticker is attached to the item, you can use some hard tools to scrape it off. However, you need to clean the dirt on your hands beforehand to prevent small equipment such as computer keyboards from being damaged when scraping. Hard tools should also be chosen to be wear-resistant to avoid scratching items during the scraping process. The scraping direction should be opposite to the direction of the sticker, and should be separated from the outer edge of the sticker inward. This can effectively reduce the area of sticker residue and avoid leaving stains.

2. Dissolution method

This is a very common method of removing thermal paper label, which involves using some chemicals to dissolve the thermal paper label. Many cleansing oils on the market are mainly composed of mineral oil. Applying mineral oil to the sticker can dissolve it. When using, first apply a small amount of mineral oil on the sticker, and then wipe it gently until the sticker is completely removed.

Another solution is to use alcohol

Applying a protective film on alcohol can significantly reduce damage to the surface of items during cleaning. This is a relatively safe method of cleaning thermal paper label, but be careful not to overuse it when using it.

3. Pressing method

When the sticker adheres to clothes or fabrics, you can press it before drying to prevent it from drying and make it easier to remove. When using it, heat up the plywood, soldering iron and other equipment (not too hot to avoid scalding the clothes), and press it on the sticker for a few seconds to make it easier to remove.

4. Warm brushwork

If it is some metal inlaid Thermal Labels, such as metal basins, you can generally use the warm brush method to process. During use, first set the temperature to the lowest temperature and gradually increase the temperature until the sticker is melted. At this point, use a rag or other tool to take it out on the melted sticker. The temperature should be controlled appropriately, not too hot to avoid scalding the surface of the object, but not too low to avoid too low efficiency.